Overview

A water-bourne varnish ideal for use on all wooden floors including hardwood, softwood boards, and parquet. The polymer chemistry gives a tough, hardwearing finish making it ideal for use in high-traffic areas such as hallways and living areas. Formulated to have a low odour and fast drying times for busy family homes.

• Ideal for high traffic areas
• Resistant to stains and spills
• Fast drying

For a professional grade floor varnish use

Preparation

Always ensure the surface to be painted is clean, dry, and dirt free to ensure adhesion.

• Fill any minor defects, imperfections, or open joints with .
• Use a scrapper to remove any resinous deposits and wipe with methylated spirits.
• New timber - Lightly abrade along the grain using a suitable abrasive paper taking care not to damage or scratch the timber surface.
• Remove all defective coatings.
• Organic growths must be removed and infected surfaces should be treated with a suitable .
• All existing finishes should be thoroughly abraded to provide a key for good adhesion.

Application

We recommend always following the manufacturer's instructions found on the tin. Stir thoroughly, it is recommended that a small test area is applied before painting the entire surface to ensure compatibility.

• Do not apply at temperatures below 8°C or above 25°C during the application or drying periods.
• Supplied ready to use do not thin.
• Use a good quality, synthetic fibre bristle brush or short pile roller, working in the direction of the wood grain.
• Apply 3 full coats allowing a minimum of 2-4 hours between coats.
• Avoid over-brushing as this may cause brush marks.
• Carefully denib between coats using a fine-grade nylon abrasive pad or a fine-grade (P240 or finer) wet or dry abrasive paper in the direction of the grain.
• Protect from water until dry.
• Avoid heavy foot traffic for 24 hours & allow 7 days before introducing carpets, rugs, or heavy furniture.

Aftercare & Storage